Cali4niaWK
12-12-2005, 08:17 PM
Some people including myself were having this problem with the 301.010 receivers. You plug in your 301 receiver to your JTAG, open up jKeys and you get ready to do a flash erase, you get as far as erasing flash 1 on the 301, then you go and try to load your new flash and it starts writing, you get to 2% 8% 34% whatever % then you get the following message: Jkeys Error: error programming flash at offset 0x60000001 So after hours of researching people who are having the same problem and this is what I have come up with. It seems that my 301 was freshly unplugged and plugged back in for this flash attempt, "No Time To Cool Down" This is where it seems to be a problem, so what I did is unplugged the receiver and sat it outside in a safe "Cool" place. 52 degrees outside here, left it outside in the cold for 45 min. brought it back in nice and cold, plugged it up went right into jKeys and started the flash process, and PERFECT, absolutly no errors. I hope this helps some people out. Also probably will work on other receivers that have simaler flash problems. Let it get cold, then while the receiver is nice and cold, do your flash attempts. If 45 min does not do it for you, let it sit outside in a safe storage place all night then try it the next morning, you might have better luck then I did in 45 Min.